Mercedes-Benz COMAND Online Supplement Manual page 32

Basic functions of COMAND
30
Switching the COMAND display on/
off
X
Press the W function button.
or
X
System
Select
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
In both cases, the system menu appears.
X
To switch off: select
press W to confirm.
X
To switch on: press one of the function
buttons, e.g. W, Ø or the % back
button.
Mute
Switching audio and video sources on/
off
X
Press the 8 button on COMAND or on
the multifunction steering wheel.
The sound from the respective audio or
video source is switched on or muted.
i When the sound is off, the system dis-
plays the , icon in the status line. When
you change the audio or video source, or
adjust the volume, sound automatically
switches on again.
i Even if the sound is switched off, you will
still hear traffic and navigation system
announcements.
Switching off Traffic Programme and
navigation announcements completely
X
Traffic Programme: press and hold the
8 button until the . display disap-
pears from the status bar of the display.
A confirmation tone sounds.
X
Navigation announcements: press the
8 button during the announcement.
in the main function bar by
Display off
Switching Traffic Programme and navi-
gation announcements on again
X
Traffic Programme: press and hold down
the 8 button until the . display in the
status bar appears.
A confirmation tone sounds.
X
Navigation announcements: switch
COMAND off and then on again
( Y page 30).
and
or
X
Start a new route calculation
( Y page 56).
or
X
If the navigation menu is shown, select
+ and press W to confirm
( Y page 81).
Adjusting the volume
Adjusting the volume for the audio or
video source
X
Turn the q control knob.
or
X
Press the W or X button on the mul-
tifunction steering wheel.
The volume of the currently selected audio
or video source changes.
You can also adjust the volume for the fol-
lowing:
traffic announcements
R
navigation announcements
R
phone calls
R
LINGUATRONIC voice control (see the sep-
R
arate operating instructions)
Adjusting the volume for traffic
announcements and navigation
announcements
i
You can set the volume of traffic and nav-
igation announcements relative to the vol-
ume of the audio or video source.