Previous Destinations - Mercedes-Benz COMAND Online Supplement Manual

X
To select an address book entry: pro-
ceed as described in the "Searching for an
address book entry" section
( Y page 141).
COMAND stores the data if the address
book entry selected does not yet contain
navigable address data.
If the selected address book entry already
contains navigable address data, a prompt
will appear asking whether you wish to
overwrite the existing data.
X
Yes No
Select or and press W to confirm.
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Dest.
Select in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X
From memory
Select
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1: destination memory list with
character bar: proceed as described in the
"Entering characters using the character
bar" section ( Y page 28).
X
Option 2: destination memory list as
selection list: select a destination by turn-
ing cVd the COMAND controller and press
W to confirm.
You see the address data of the selected
entry.
X
Delete
Select and press W to confirm.
A prompt appears asking whether you wish
to delete the destination.
and press W to con-

Previous destinations

X
Yes No
Select or and press W to confirm.
If you select Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No, the process will be aborted.
i If the navigable address data for the des-
tination being deleted is also assigned to
an address book entry, COMAND will also
delete this data from there. If the corre-
sponding address book entry does not con-
tain any further data, such as telephone
numbers, COMAND deletes the entire
address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
has been started. If the memory is full,
COMAND deletes the oldest destination. You
can also save a destination from the list of
previous destinations in the destination mem-
ory. It will be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
( Y page 94).
Storing the vehicle position in the list
of previous destinations
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Position
Select in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
95
Z