Mercedes-Benz COMAND Online Supplement Manual page 65

X
To select a category: select a category by
turning cVd the COMAND controller and
press W to confirm.
COMAND first searches in the selected cat-
egory for destinations along the route. If
there are no destinations available there,
COMAND searches for destinations within
a radius of up to 100 km of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the dis-
play.
Search result for the selected category FILLING
STATION (example)
Highlighted intermediate stop, current
:
distance from the vehicle position and
name of the intermediate stop
The intermediate stops along the route are
displayed at the top of the list, sorted by
increasing distance from the vehicle's current
position. Below this you will see the inter-
mediate stops that COMAND finds in the
vicinity of the vehicle's current position.
i For intermediate stops that are not loca-
ted along the calculated route, the linear
distance is shown.
X
Select the intermediate stop by turning
cVd the COMAND controller and press
W to confirm.
The address entry menu appears, showing
the destination address.
X
To start route calculation: select
and press W to confirm.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm
X
Select a different category.
Deleting an intermediate stop
If an intermediate stop has already been
entered, you can delete it.
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Stopover
Select
X
Delete stopover
Select
confirm.
COMAND deletes the intermediate stop
and recalculates the route to the main des-
tination.
Entering waypoints
Introduction
You can map the route yourself by entering
up to two waypoints. The sequence of the
waypoints can be changed at any time.
i An intermediate stop is always between
the current position of the vehicle and the
first waypoint.
Creating waypoints
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
Start
Destination entry
OK
by pressing W.
in the navigation sys-
and press W to confirm.
and press W to
63
Z