Mercedes-Benz COMAND Online Supplement Manual page 64

Destination entry
62
Entering a destination using geo-coor-
dinates
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Using geo-coordinates
Select
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates.
X
To change a value: turn cVd the
COMAND controller.
X
To move the mark within the line: slide
XVY the COMAND controller.
X
To move the mark between the lines:
slide ZVÆ the COMAND controller.
X
To confirm the value: press W the
COMAND controller.
i If the selected position is outside the dig-
ital map, COMAND uses the nearest digi-
tised road for route calculation. You will see
The position is off the map
the
sage. If the selected position is located
over a body of water, you will see the mes-
The destination is located in
sage:
a body of water. Please select
another destination.
in the navigation sys-
and
mes-
Entering an intermediate stop
Introduction
You can use this function to enter an inter-
mediate stop while the vehicle is in motion.
COMAND provides a selection of predefined
destinations in eight categories for this pur-
FILLING STATION
pose, e.g.
When you have entered your intermediate
stop, COMAND automatically recalculates
the route to the main destination.
Entering predefined destinations
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Stopover
Select and press W to confirm.
Option 1: the route does not have an inter-
mediate stop.
Intermediate stop categories
X
Select a category, see option 2.
Option 2: the route already has an inter-
mediate stop.
X
Change stopover
Select
confirm.
or CAFÉ.
in the navigation sys-
and press W to