Using Dual Rtps To Field Wiring The 32 Point Dc Do - Honeywell ControlEdge 900 platform Hardware Planning And Installation Manual

Appendix A - Installing RTP

Using Dual RTPs to field wiring the 32 Point DC DO

To wire the 32 Point DC DO using dual RTPs:
1. Mount the RTP cable assembly to ControlEdge 900 Controller. See the
210
ATTENTION:
RTP and cables are intended for permanent installation within their own
l
enclosure.
32 point DC Digital Output is limited to 6A per RTP and 0.5A per output.
l
following figure for the example installation diagram.
a. Remove the relevant key tabs from the terminal block to allow connection
with the module.
b. Connect the appropriate cable to the module at ControlEdge 900
Controller. Possible options are:
900RTC-3410 Remote Terminal Cable assembly, 1.0 meters long
l
900RTC-3425 Remote Terminal Cable assembly, 2.5 meters long
l
c. Install the module label onto the module connector cover.