Using Dual Rtps To Field Wiring The 32 Point Dc Di - Honeywell ControlEdge 900 platform Hardware Planning And Installation Manual

Appendix A - Installing RTP

Using Dual RTPs to field wiring the 32 Point DC DI

ATTENTION: RTP and cables are intended for permanent installation within
their own enclosure.
To wire the 32 Point DC DI using dual RTPs:
1. Mount the RTP cable assembly to ControlEdge 900 Controller. See the
204
ATTENTION: SDC+ in the wiring figure below refers to power that is
disconnected from these screw terminals when switch SW1 is open (0).
following figure for the example installation diagram.