Mitsubishi Electric MELSEC iQ-R Series User Manual page 58

• For HOLD setting
While the wave output is paused, analog output value during the pause is held.
CPU module status
CH1 D/A conversion enable/disable
setting (Un\G500)
CH1 Output enable/disable
flag (Y1)
CH1Wave output start/stop request
(Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output set in CH1 Output setting
during wave output stop
(Un\G524)
• For CLEAR setting
While the wave output is paused, the offset value is output.
CPU module status
CH1 D/A conversion enable/disable
setting (Un\G500)
CH1 Output enable/disable
flag (Y1)
CH1Wave output start/stop request
(Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output set in CH1 Output setting
during wave output stop
(Un\G524)
1 FUNCTIONS
56
1.14 Wave Output Function
OFF
Wave output stop
Wave output start
request (0)
request (1)
Wave output stop (0)
Analog output
Offset value
OFF
Wave output stop
Wave output start
request (1)
request (0)
Wave output stop (0)
Analog output
Offset value
RUN
D/A conversion enable (0)
ON
Wave output pause
request (2)
Wave Wave output
output (1) pause (2)
If HOLD is set to the analog
output HOLD/CLEAR
function, the analog output
value is held.
RUN
D/A conversion enable (0)
ON
Wave output pause
request (2)
Wave Wave output
output (1) pause (2)
If CLEAR is set to the
analog output HOLD/CLEAR
function, the offset value
is output.
Wave output start request (1)
Wave
Wave output stop (0)
output
(1)
Wave output start request (1)
Wave
output Wave output stop (0)
(1)