Mitsubishi Electric MELSEC iQ-R Series User Manual page 149

CH1 Wave pattern output count monitor
The output count of the wave pattern can be checked.
Only when the wave output function is used and the operation mode is normal mode, a value is stored in the area. Otherwise,
0 is stored.
The stored value increases by one every time one cycle of a wave pattern is output. The measuring range is from 0 to 32767.
When the wave pattern output repetition setting is set to Unlimitedly repeat output, the count returns to 0 and starts again from
1 after the 32767th count. (32766  32767  0  1  2 )
In the following cases, the stored value is reset.
• When 'Operating condition setting request' (Y9) is turned on and off
• When the wave output status transitions from During wave output stop to another wave output status
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave pattern output count monitor
CH Wave pattern output count monitor (When
the Q compatible mode function is used)
CH1 Wave output current address monitor
In the wave output mode, which data in the wave data registry area is D/A-converted and output can be checked.
Only in the wave output mode, the buffer memory address of the wave output data is stored in this area.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave output current address monitor
CH Wave output current address monitor
(When the Q compatible mode function is used)
CH1 CH2 CH3
434 634 834
1124 1125 1126
CH1 CH2 CH3
436 636 836
437 637 837
1132 1134 1136
CH4 CH5 CH6
1034 1234 1434
1127 1128 1129
CH4 CH5 CH6
1036 1236 1436
1037 1237 1437
1138 1140 1142
Appendix 3 Buffer Memory
CH7 CH8
1634 1834
1130 1131
CH7 CH8
1636 1836
1637 1837
A
1144 1146
APPENDICES
147