Mitsubishi Electric MELSEC iQ-R Series User Manual page 163

CH1 Wave pattern start address setting
This area is for setting the start address of the wave pattern to be output when the wave output function is used.
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
In the channel where the set values in this area and in 'CH1 Wave pattern data points setting' (Un\G528, Un\G529) satisfy the
following conditions, a wave data registry area range error (error code: 1D9H) occurs and 'Error flag' (XF) turns on. The
wave output does not start.
(Wave pattern start address setting + Wave pattern data points setting - 1) > 89999 (the last buffer memory address of the
wave data registry area)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave pattern start address setting
CH Wave pattern start address setting (When
the Q compatible mode function is used)
■Setting range
The setting range is from 10000 to 89999 (10000 to 89999 of the buffer memory).
In the channel where a value out of the setting range is set, a wave pattern start address setting range error (error code:
1D4H) occurs and 'Error flag' (XF) turns on. The wave output does not start.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is 10000 for all channels.
CH1 CH2 CH3
526 726 926
527 727 927
1024 1026 1028
CH4 CH5 CH6
1126 1326 1526
1127 1327 1527
1030 1032 1034
Appendix 3 Buffer Memory
CH7 CH8
1726 1926
1727 1927
1036 1038
A
APPENDICES
161