Mitsubishi Electric MELSEC iQ-R Series User Manual page 150

CH1 Wave output current digital value monitor
The digital value of the current output wave can be checked.
Only in the wave output mode, a value is stored in this area. The stored value differs depending on the wave output status.
Otherwise, 0 is stored.
The following shows the correspondence relation between the wave output status and the stored value.
• During wave output stop
Output digital value selected in 'CH1 Output setting during wave output stop' (Un\G524)
Setting value of Output setting during wave output stop
0V/0mA (0)
Offset value (1)
Setting value during stop (2)
• During wave output
Digital value stored in the buffer memory address indicated with 'CH1 Wave output current address monitor' (Un\G436 to
Un\G437)
• Wave output pause
The value differs depending on the analog output HOLD/CLEAR setting.
Setting of analog output HOLD/CLEAR function
HOLD setting
CLEAR setting
• During wave output step action
Digital value stored in the buffer memory address indicated with 'CH1 Wave output current address monitor' (Un\G436 to
Un\G437)
When 'Operating condition setting request' (Y9) is turned on and off, the stored value is reset.
The stored value of when the D/A conversion and output are enabled is shown. For the analog output in other statuses, refer
to the following.
Page 20 In the wave output mode
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave output current digital value monitor
CH Wave output current digital value monitor
(When the Q compatible mode function is used)
APPENDICES
148
Appendix 3 Buffer Memory
Stored value
0
Setting value of 'CH1 Output value during wave output stop' (Un\G525)
Stored value
Digital value stored in the buffer memory address indicated with this area
0
CH1 CH2 CH3
438 638 838
1148 1149 1150
CH4 CH5 CH6
1038 1238 1438
1151 1152 1153
CH7 CH8
1638 1838
1154 1155