Mitsubishi Electric MELSEC iQ-R Series User Manual page 46

■When the digital input values are different between the start point and the end point
The wave pattern end point is output in analog as it is. The set wave patterns are continuously output in analog regardless of
the setting in 'CH1 Wave pattern output repetition setting' (Un\G530).
A wave pattern that is repeatedly
output in an analog value
The digital input values are
different between the start
point and the end point.
*1 The output cycle of a wave pattern is calculated by the following formula.
Output cycle of a wave pattern = (Wave output conversion cycle)  (Wave pattern data points)
For details on the wave output conversion cycle, refer to the following.
Page 45 Wave output conversion cycle
Ex.
Calculating the output cycle of a wave pattern
Setting item
CH1 D/A conversion enable/disable setting
CH1 Wave pattern data points setting
CH1 Wave pattern output repetition setting
CH1 Constant for wave output conversion cycle
With the above setting, the output cycle of a wave pattern becomes as follows. (When the D/A conversion is enabled only for
CH1)
Output cycle of
=
a wave pattern ( s)
=
=
1 FUNCTIONS
44
1.14 Wave Output Function
Analog output
1 cycle
*1
The digital input values of the end point
and the start point of the next iteration
are consecutively output in an analog value.
Number of channels
Conversion
×
where D/A conversion
speed
is enabled
× × ×
80 1 1
8080
*1
1 cycle
Setting value
D/A conversion enabled (0)
101
3
1
Constant for
×
wave output
conversion cycle
101
1 cycle
For the case where the wave pattern is repeatedly output
a limited number of times, the wave pattern is output a
number of times specified in Wave pattern output
repetition setting, and then the value is output according
to the setting in Output setting during wave output stop.
Wave pattern
×
data points