Mitsubishi Electric MELSEC iQ-R Series User Manual page 57

■Pausing the wave output
• To pause the wave output, set Wave output pause request (2) to 'CH1 Wave output start/stop request' (Un\G462). When
Wave output start request (1) is changed to Wave output pause request (2), the wave output is paused. Wave output pause
(2) is stored to 'CH1 Wave output status monitor' (Un\G401).
• To resume the wave output, change the value in 'CH1 Wave output start/stop request' (Un\G462) from Wave output pause
request (2) to Wave output start request (1). The wave output is resumed from the paused point.
• When Wave output pause request (2) is set to 'CH1 Wave output start/stop request' (Un\G462) during the wave output stop,
the digital input value of the wave pattern start address is output in analog after the D/A conversion.
CPU module status
CH1 D/A conversion enable/disable
setting (Un\G500)
CH1 Output enable/disable
flag (Y1)
CH1Wave output start/stop
request (Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output set in CH1 Output setting
during wave output stop (Un\G524)
The analog output value while the wave output is paused differs depending on the setting of the analog output HOLD/CLEAR
function. For details, refer to the following.
Page 20 In the wave output mode
D/A conversion enable (0)
OFF
Wave output stop
Wave output
request (0) start request (1)
Wave
Wave output stop (0)
output (1)
Analog output
Offset value
RUN
ON
Wave output pause
Wave output start request (1)
request (2)
Wave
Wave output
output
pause (2)
(1)
(2)
(1)
(1): Wave output pauses when Wave output pause request (2) is set to CH1
Wave output start/stop request (Un\G462) during the wave output.
(2): Wave output resumes when Wave output start request (1) is set to CH1
Wave output start/stop request (Un\G462) during the wave output pause.
1.14 Wave Output Function
Wave output stop (0)
1 FUNCTIONS
55
1