Mitsubishi Electric MELSEC iQ-R Series User Manual page 174

Output setting during synchronous Error
Select whether to continue or stop the synchronization of the D/A converter modules when an inter-module synchronization
cross-cycles processing error (error code: 2600H) or inter-module synchronization signal error (error code: 2610H) occurs.
Setting value
0
1
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Output setting during synchronous Error
Output setting during synchronous Error (When
the Q compatible mode function is used)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Synchronization continues (0).
Synchronization status monitor
This area is for checking whether the D/A converter module is set as a target or a non-target of the inter-module
synchronization function, and the inter-module synchronization status (synchronization in progress/during synchronization)
when the inter-module synchronization function is used.
Monitor value
0
1
2
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Synchronization status monitor
Synchronization status monitor (When the Q
compatible mode function is used)
APPENDICES
172
Appendix 3 Buffer Memory
Description
Synchronization continues
Synchronization stops
CH1 CH2 CH3
9532
2032
Description
Inter-module synchronization non-target
Inter-module synchronization target (synchronization at rest)
Inter-module synchronization target (during synchronization)
CH1 CH2 CH3
9600
2100
CH4 CH5 CH6
CH4 CH5 CH6
CH7 CH8
CH7 CH8