Mitsubishi Electric MELSEC iQ-R Series User Manual page 161

CH1 Output setting during wave output stop
Select the output during wave output stop when the wave output function is used.
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
Analog output
0V/0mA
Offset value
Output value during wave output stop
*1 Set value of 'CH1 Output value during wave output stop' (Un\G525)
In the channel where a value out of the setting range is set, an output setting during wave output stop setting range error
(error code: 1D2H) occurs and 'Error flag' (XF) turns on. The operation of the wave output before the change continues.
When Output value during wave output stop (2) is set for this area, set a value in 'CH1 Output value during wave output stop'
(Un\G525).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Output setting during wave output stop
CH Output setting during wave output stop
(When the Q compatible mode function is used)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Offset value (1) for all channels.
*1
CH1 CH2
524 724
1008 1009
Setting value
0
1
2
CH3 CH4 CH5
924 1124 1324
1010 1011 1012
CH6 CH7 CH8
1524 1724 1924
1013 1014 1015
APPENDICES
Appendix 3 Buffer Memory
A
159