Futurecom Mobexcom P25 Installation & Programming Manual page 68

Field Name
Enable /
Fallback in
Disable check
Analog Simplex
box.
Mode Enabled
Steering Hang
0-60 seconds
Time
Disable MSU Mic
Enable /
PTT DVR Repeat Disable check
in SYS Mode box.
Digital Vehicular Repeater Interfaced to XTL
April 2014
DVRS Installation & Programming Guide – PART II
Range
If enabled, a non-Primary DVR that
detects a valid Inbound or Outbound Call
will monitor for Primary DVR repeating
the call and if such is not detected, the
non-Primary DVR will repeat the call.
The non-primary DVR only temporarily
repeats the call and does not become a
Primary when Primary repeat is not
detected. The first few seconds of the
Inbound or Outbound Call are always
lost while the non-Primary DVR is
checking for Primary repeat and deciding
if fallback is needed.
When programmed to 0, the MSU stays
on the steered mode after the PSU
inbound call is over.
If programmed to >0, the DVR forces the
MSU to return to the original MSU mode
when the PSU inbound call ends and the
programmed timer expires.
When Enabled, the DVR does not
transmit audio to the LPSUs when the
MSU Mic is PTT-ed and the DVR is in
the SYS mode.
Default setting is unchecked i.e. MSU
Mic PTT audio is transmitted by both the
MSU and the DVR when the DVR is in
SYS Mode.
TM
5000 (O3 or O5) or XTL
Description
TM
2500 (M5)
8M083X01 Rev. 16
6881013Y39
Notes
Applicable to Simplex
Analog DVR Mode only.
Applicable to Analog
DVR Mode only.
This feature is used in
single DVR user
applications in order to
prevent feedback from
the MSU MIC and the
PSU when the user is
inside the vehicle.
Page 32 of 79