Psu Id Data; Vr Activation Radio Id Data; Tg Translation Id Data; System Setup 1 Menu - Futurecom Mobexcom P25 Installation & Programming Manual

PSU ID Data

This menu screen is used to specify PSU IDs (or range of IDs) that are allowed to be
affiliated on the system via DVRS. If analog portables are used and MDC ID pass
through is required, then the PSU MDC ID must be enabled on the System and included
in the PSU ID Data list of the DVR.
If the range is set to be from '0' to '- -', then any PSU ID is allowed to talk through the
DVRS.
This screen is Password protected. To view the range of IDs the User needs to enter a
password. To change the PSU ID list the User needs to log in as Admin (requires
password).

VR Activation Radio ID Data

This screen allows the user to enter the console or system radio IDs range of units that
can page the MSU and toggle the DVR mode. Default list is empty i.e. when the MSU is
paged the DVR mode is not changed provided the MSU is programmed to have the
remote activation disabled (Radio Wide, 'System Remote Activation/Deactivation'
unchecked). If the 'System Remote Activation / Deactivation' box is checked in the MSU
then any Call Alert Page to the MSU will trigger DVRS mode change, which can result in
loss of vital communications.

TG Translation ID Data

TG Translation is used when the Local PSU needs to operate on more then 96 TGs
and the System is P25 Trunking or P25 Conventional.
When TG translation is enabled, the Local PSU transmits on TG A, which then is
translated by the DVRS to the TG currently selected on the MSU's control head. The
Local PSU can be programmed with just one TG (TG A) and it will talk on any TG that is
programmed and selected on the MSU. The TG Translation ID Data Table allows the
user to program the Local PSU TG IDs that are enabled for TG Translation. The default
list is empty, i.e. TG translation is disabled. The Local PSU must be programmed with
Normal squelch or NAC=F7E in order to be able to receive Outbound (System) or MSU
Mic PTT calls when TG Translation is enabled.
NOTE: Encryption Key Translation is not supported by the DVRS.

System Setup 1 Menu

Field Name
Enable /
Repeater Active
Disable check
Tones
box
Enable /
Local Mode
Disable check
Active Tones
box
Digital Vehicular Repeater Interfaced to XTL
April 2014
DVRS Installation & Programming Guide – PART II
Range
Enables / Disables the sending of tones
when the DVR is switched to System
(and optionally
repeater active tones are transmitted
over the air to all Local PSUs tuned to
the same DVR conventional channel.
Enables / Disables the sending of tones
when the DVR is switched on in Local
Mode. The repeater active tones are
transmitted over the air to all Local PSUs
tuned to the same DVR conventional
channel. Requires
'Repeater Active Tones'
TM
5000 (O3 or O5) or XTL
Description
Local) Mode. The
enabling of the
Field.
TM
2500 (M5)
8M083X01 Rev. 16
6881013Y39
Notes
Tones are sent when
switching from OFF to
LOC or OFF to SYS
occurs. Tones are not
sent when switching SYS
to LOC or LOC to SYS.
Tones are sent when
switching from OFF to
LOC or OFF to SYS
occurs. Tones are not
sent when switching SYS
to LOC or LOC to SYS.
Page 30 of 79