Hardware Setup Menu - Futurecom Mobexcom P25 Installation & Programming Manual

Field Name Range
VR Ch List 0 - max # of
programmed
DVR
channels
Emergency ACK 'VR ACK'
type 'Site ACK'
'Console
ACK'
Emergency Revert Read Only
Pers. Nr. Read Only
ANN. TG(h)
Read Only
RCM (hex)
Read Only
Mob Det
Number

Hardware Setup Menu

Field Name Range
RSSI
2-20dB
OFF
Hysteresis
Speed
1-10ms
Squelch
ON Threshold
4-28dB
OFF 3-25dB
Threshold
Speed 10-150ms
Reptr FM Dev.
Limit
12.5kHz
0.75–2.5kHz
25kHz
1.5 - 5kHz
Digital Vehicular Repeater Interfaced to XTL
April 2014
DVRS Installation & Programming Guide – PART II
Description
Enables the selection of which DVR
channels are selectable when a
specific MSU TG / Channel is
selected on the O5 / O3 / M5.
If set to 'VR ACK' – emergency sent
by the local PSU and received by the
DVR is immediately acknowledged by
the DVR.
The DVR sends ACK to the PSU only
after FNE Site ACK or RCM ACK
when this field is set to
'Console ACK' respectively.
This field is extracted during the
"Import Motorola CSV File"
process.
This field is extracted during the
"Import Motorola CSV File"
process.
This field is extracted during the
"Import Motorola CSV File"
process.
This field is extracted during the
"Import Motorola CSV File"
process.
Specifies the indexed 'Item number'
(in the Tweaker Mobile Radio
Channel Setup screen) of the MSU
mode that the DVR needs to steer the
MSU to when executing the Mobile
Detector Function. The indexed 'Item
number' points to the Zone/Channel
that is programmed as Simplex only
using the MSU Tx frequency.
Description
Sets the RSSI CAS OFF threshold in
dB below the RSSI CAS ON Threshold
(see Repeater Channel Setup
Sets the RSSI Averaging Integration
Time.
Sets the Squelch ON and OFF
thresholds.
Squelch Averaging Integration Time.
Typically set to 2.12kHz (12.5kHz
channel spacing) or 4.25kHz (25kHz
channel spacing.
TM
5000 (O3 or O5) or XTL
Applicable only if the
Ch All Alwd"
"No".
Applicable only when the
'Portable Ack Rq'
the Emergency Mode
Setup screen is enabled
(checked).
'Site ACK' or
Refer to the
Motorola CSV File"
paragraph.
Refer to the
Motorola CSV File"
paragraph.
Refer to the
Motorola CSV File"
paragraph.
Refer to the
Motorola CSV File"
paragraph.
Requires the MSU to be
programmed with extra
channels in order to
execute the Mobile
Detector function.
See the Mobile Detector
section for more
information.
Menu). Typically set to 5dB.
Typically set to 1ms.
Affects Analog Mode only.
Typical recommended settings
are ON: 16dB SINAD
OFF: 10dB SINAD.
Typical setting is 25ms.
Affects Analog Mode only.
Depends on the selected
Channel Spacing – refer to the
Frequency Band Setup
TM
2500 (M5)
8M083X01 Rev. 16
6881013Y39
Notes
"VR
field is set to
field on
"Importing
"Importing
"Importing
"Importing
Notes
menu.
Page 27 of 79