Introduction; Starting Setup; Using Setup - IEI Technology HYPER-AL series User Manual

HYPER-AL SBC

5.1 Introduction

The BIOS is programmed onto the BIOS chip. The BIOS setup program allows changes to
certain system settings. This chapter outlines the options that can be changed.
NOTE:
Some of the BIOS options may vary throughout the life cycle of the
product and are subject to change without prior notice.

5.1.1 Starting Setup

The UEFI BIOS is activated when the computer is turned on. The setup program can be
activated in one of two ways.
1. Press the D
2. Press the D
appears on the screen.
If the message disappears before the D
and try again.

5.1.2 Using Setup

Use the arrow keys to highlight items, press E
PageDown keys to change entries, press F1 for help and press E
keys are shown in Table 5-1.
Key Function
Up arrow Move to previous item
Down arrow Move to next item
Left arrow Move to the item on the left hand side
Right arrow Move to the item on the right hand side
+ Increase the numeric value or make changes
or F2 key as soon as the system is turned on or
ELETE
or F2 key when the "Press Del to enter SETUP" message
ELETE
0.
or F2 key is pressed, restart the computer
ELETE
to select, use the PageUp and
NTER
to quit. Navigation
SC
Page 47