System Configuration; At/Atx Mode Select Switch; Figure 4-4: At/Atx Mode Select Switch Location; Table 4-1: At/Atx Mode Select Switch Settings - IEI Technology HYPER-AL series User Manual

HYPER-AL SBC

4.5 System Configuration

The system configuration is controlled by buttons, jumpers and switches. The system
configuration should be performed before installation.

4.5.1 AT/ATX Mode Select Switch

CN Label:
CN Type:
CN Location:
CN Settings:
The AT/ATX mode select switch specifies the systems power mode as AT or ATX.
AT/ATX mode select switch settings are shown in Table 4-1.
Setting
Short 1-2
Short 2-3

Table 4-1: AT/ATX Mode Select Switch Settings

The location of the AT/ATX mode select switch is shown in Figure 4-4 below.

Figure 4-4: AT/ATX Mode Select Switch Location

J_ATX_AT1
Switch
See Figure 4-4
See Table 4-1
Description
ATX Mode (Default)
AT Mode
Page 41