Buzzer Connector; Figure 3-4: Battery Connector Location; Table 3-4: Battery Connector Pinouts - IEI Technology HYPER-AL series User Manual

The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.

Figure 3-4: Battery Connector Location

Pin Description
1 VBAT+
2 GND

Table 3-4: Battery Connector Pinouts

3.2.1 Buzzer Connector

NOTE:
If you cannot find a good place to put a buzzer on the HYPER-AL, it is
recommended to attach the buzzer onto the system chassis in which
the HYPER-AL is installed.
CN Label: SP1
2-pin wafer, p=1.25 mm
CN Type:
CN Location: See Figure 3-5
CN Pinouts: See Table 3-5
The buzzer connector is connected to a buzzer.
Page 18
HYPER-AL SBC