Internal Peripheral Device Connections; Sata Drive Connection - IEI Technology HYPER-AL series User Manual

Pico-itx sbc with 14nm intel celeron n3350 soc, hdmi, lvds, dual pcle gbe, usb 3.0, m.2 slots, sata6g/s, rs-232, hd audio and rohs

Table of Contents

4.7 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

The HYPER-AL is shipped with one SATA cable. To connect the SATA drive to the

connector, please follow the steps below.

Step 1:

Locate the SATA connector and the SATA power connector. The locations of

the connectors are shown in Chapter 3.

Step 2:

Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector and the SATA power connector. See Figure 4-6.

NOTE:

The connector locations in the following diagram are just for reference.

For the exact locations, please see Section 3.2.3 and Section 3.2.4.

Page 44

HYPER-AL SBC

Table of Contents