Lvds Lcd Connector; Figure 3-9: Lvds Connector Location - IEI Technology HYPER-AL series User Manual

3.2.2 LVDS LCD Connector

CAUTION:
1. The LVDS connector is disabled by default. To enable LVDS, please
enter BIOS menu, and go to "Chipset  North Bridge Configuration
LCD Control" to configure it (refer to Section 5.4.1.2).
2. Pin 16 on the LVDS cable must be GROUND; otherwise the system
will not display through LVDS even the LVDS cable is connected to the
HYPER-AL and the LVDS BIOS option is enabled.
CN Label: LVDS1
CN Type: 20-pin crimp, p=1.25 mm
CN Location: See Figure 3-9
CN Pinouts: See Table 3-8
The LVDS connector is for an LCD panel connected to the board.

Figure 3-9: LVDS Connector Location

Page 22
HYPER-AL SBC