7.4
Malfunctions of the two-in-one blade holder E
7.4.1 Replacing the pressure plate
1
Fig. 137
1. Bring the safety guard down
2. Rotate the clamping lever counterclockwise
3. Pull out the bolt
4. Remove the damaged pressure plate
Tips
Make sure that the insert of the clamping top is installed as shown
falls out. If it is installed wrongly, the pressure plate cannot be clamped.
5. Install a new pressure plate.
6. Insert the bolt
7. Rotate clamping lever clockwise
HistoCore AUTOCUT
3
(→ "Fig.
137-1").
(→ "Fig. 137-3") (→ "Fig.
(→ "Fig.
(→ "Fig.
138-3").
(→ "Fig.
5
2
Fig. 138
(→ "Fig.
137-2").
138-3").
138-4").
138-2").
Troubleshooting
(→ "Fig. 138-5")
in case it
7
2
4
3
107