Knife Holder E With A Water Trough For Low-Profile Blades - Leica HistoCore AUTOCUT Instructions For Use Manual

1
Fig. 83

6.3.4 Knife holder E with a water trough for low-profile blades

3
Fig. 84
Tips
The clamping levers on the knife holder are not interchangeable. The two clamping levers
84-2") and (→ "Fig.
malfunctions of the knife holder can occur.
Clamping lever for the blade
(→ "Fig. 84-3") is at the left.
HistoCore AUTOCUT
2
1
2
84-3")) must remain in the position shown at all times, as otherwise isolated
(→ "Fig. 84-2")
Lateral displacement
The lateral movement feature of the two-in-one
blade holder E enables the use of the entire length
of the blade by moving the clamping top laterally.
Three predefined stop positions (left, center,
right) that correspond to the width of a standard
cassette may be used if desired.
• To release the clamping, rotate the lever
(→ "Fig. 83-1")
blade holder E counterclockwise.
• Move the clamping-top
• To clamp, rotate the lever
clockwise.
The knife holder E with a water trough
84") is only for low-profile blades.
The safety guard on knife holder E consists of a
red foldaway handle
cutting edge, fold the safety guard handle
84-1") clockwise as illustrated in the figure.
is at the right, clamping lever for the lateral displacement
Optional Accessories
on the left side of the two-in-one
(→ "Fig. 83-2")
(→ "Fig. 83-1")
(→ "Fig. 84-1"). To cover the
6
laterally.
(→ "Fig.
(→ "Fig.
((→ "Fig.
79