Inclination (declination) of the knife holder SN
• Loosen the clamping lever
• Set the required declination (inclination of the knife holder from the cutting direction) on the scale
(→ Fig. 14-2)
at the back of the knife holder
• On the intermediate plate
of reference for the scale division when adjusting the declination.
• For fixation, tighten the clamping lever
4.6
Assembling the blade holder SE
The blade holder SE is designed for conventional disposable blades from all common manufacturers.
It is available in two models: one for low-profile blades and one for high-profile blades. The blade holder
SE has a lateral movement, so that the entire width of the blade can be used.
Warning
Important!
The mounting table must be absolutely clean and dry. There must not be any foreign particles on it.
Otherwise, sections could become contaminated.
Leica SM2010 R
(→ Fig.
14-1).
(→ Fig. 14-4)
there is an index mark
(→ Fig. 14-1)
3
4
Fig. 14
(→ Fig.
14-3).
(→ Fig. 14-5)
firmly in the required position.
2
5
Instrument Setup
which serves as a point
1
4
23