Adjusting Scan Parameters - NT-MDT NTEGRA Spectra Instruction Manual

9.4. Adjusting Scan Parameters

Scanning is performed by the sample with the use of the scanner of the exchangeable
mount. Scanning parameters are adjusted with the
1. Go to the
Scan(Master)
tab (Fig. 9-14).
Spectra
2. Select between 2D and 3D scanning with the
button corresponds to 2D scanning while state "pressed-in" means 3D scan (Fig. 9-15).
a) 2D scanning
Fig. 9-15. Selecting dimensionality and direction of scanning
3. Select direction of scanning in the drop-down list (Fig. 9-15).
4. Define numbers of scan points at every direction:
for 3D scanning – enter numbers of points in the input fields for every direction
-
(Fig. 9-16).
for 2D scanning – enter numbers of points in the input fields for selected
-
directions. The input field for the third direction will be inaccessible.
Fig. 9-16. Defining numbers of scan points for every direction
5. Select the scan area.
Chapter 9. Measuring with the Confocal Microscopy Mode
tab by clicking the corresponding title at the left top of the
Fig. 9-14
X Y
tab.
Scan(Master)
button. State "released" of the
b) 3D scanning
Z
39