NT-MDT NTEGRA Spectra Instruction Manual page 45

Fig. 9-27.
b. Go to the
Range
c. In the
Centre
detected spectrum so that the bounds
–1
0÷600 cm .
d. Click the
OK
Spectral acquisition setup
5. Open the
Scan(Slave)
of the tab.
Spectra
6. Choose a signal for registration:
a. Open the
Select Signal
Control panel of the
b. Select the
CCD
Chapter 9. Measuring with the Confocal Microscopy Mode
Range Spectral acquisition setup
tab of the
tab by selecting the corresponding title.
input field of the
Spectrum Range
button to enable the modifications and to close the
window.
tab (Fig. 9-28) by clicking the corresponding title in the left top
Fig. 9-28. Control panel of the
window (Fig. 9-29) with the
tab.
Scan(Slave)
option in the
Select Signal
window
panel, define the center of the
and embrace the range of
Low High
Scan(Slave)
tab
window.
button in the
45