NT-MDT NTEGRA Spectra Instruction Manual page 53

5. Moving the head in the XY plane (Fig. 10-4), bring the spots both from the SNOM
head laser and from the spectrometer laser into coincidence.
6. Approach the probe tip to the sample.
Turning off the laser beam of the spectrometer
For measurements in the mode of fluorescent Scanning Near-field Optical Microscope, the
laser beam of the SNOM head is used.
Turn off the laser of the spectrometer by turning the key of the laser power supply to the
position.
OFF
Adjusting the spectrometer
To adjust the spectrometer for operating with the laser of the SNOM head, perform the
following:
1. Go to the
Spectra
2. Go to t he
Renishaw CCD
tab.
Spectra
3. Open the
Measure ent Settings m
Fig. 10-4. Moving screws of the measuring head
1 – X-movement screw; 2 – Y-movement screw
tab by clicking the
tab by clicking the corresponding title at the left top of the
Spectral acquisition setup
button.
Chapter 10. Other Capabilities
but ton in the Main Operations Panel.
window (Fig. 10-5) with the
53