Measuring With The Confocal Microscopy Mode; Configuring The Instrument - NT-MDT NTEGRA Spectra Instruction Manual

NTEGRA Spectra Probe NanoLaboratory. (Inverted Configuration with Renishaw Spectrometer).

9. Measuring with the Confocal Microscopy Mode

Preparation of the device for operation (see Chapter
measurements with confocal microscopy techniques.
The confocal scanning includes the following main operations:
1. Configuring the Instrument (see i.
2. Approaching the Sample and Focusing the Laser Beam (see i.
3. Adjusting Channels of Detection (see i.
4. Adjusting Scan Parameters (see i.
5. Additional Adjusting for Scanning with AFM head (see i.
6. Scanning (see i. 9.6
7. Saving Data (see i.
8. Finishing the Work (see i.

9.1. Configuring the Instrument

The delivery set depends on the customer's choice. It can include different measuring
units' subsets, either Inverted, or Podule, or both of them.
If the delivery set includes only one measuring unit, the Control program is configured for
operation with that unit by the manufacturer.
If the delivery set includes both measuring units, a proper configuring procedure of the
Control program should be performed depending on which of the units will perform
measurements. To configure the program, perform the following steps:
1. Go to the
Spectra
2. Go to t he
Renishaw CCD
tab.
Spectra
3. To use the Inverted measuring unit, select the
(Fig. 9-1). To use the Podule measuring unit, deselect that option.
Fig. 9-1. Selecting the
32
9.1 on page 32)
9.4 on page 39)
on page 46)
9.7 on page 49)
9.8 on page 49)
tab by clicking the
tab by clicking the corresponding title at the left top of the
Override podule position
8 on p. 30) is supposed before starting
9.3 on page 34)
9.5
but ton in the Main Operations Panel.
Override podule position
9.2 on page 33)
on page 40)
option
option