Saving Data; Finishing The Work - NT-MDT NTEGRA Spectra Instruction Manual

Clicking the
scan point with the functions selected in the
tab. Outputs of the functions will be displayed in separate 2D viewers.
CCD

9.7. Saving Data

Data collected during the scanning procedure are stored in the RAM. They can be viewed
and analyzed in the
Operations panel).
To save the data on the hard disk, perform the following steps:
1. Select the 
File
2. A dialog box will appear. Define the folder to store the data (by default, it is
C:\Program Files\NT-MDT\Nova).
3. Type in a filename and save it with the extension *.mdt.

NOTE. By default, the images obtained are stored in files "NoNameXX.mdt",
where XX is the file index in the folder Nova .

9.8. Finishing the Work

1. Regarding the detector in use, perform the following steps:
Andor CCD
Enter 20 °C for heating temperature of the CCD-matrix in the
the Control panel of the
temperature.

ATTENTION! Do not close the Control program if temperature of the
CCD-matrix is lower 0 С.
Renishaw CCD
The Renishaw CCD camera stops operation automatically after the spectrometer is
switched off.
2. If the configuration of AFM-Spectrometer or SNOM-Spectrometer was used, open the
feedback loop by releasing the
Chapter 9. Measuring with the Confocal Microscopy Mode
button results in analyzing the selected spectrum regions at every
tab (accessible through the
Data
Main menu command.
Save
tab. Wait until the CCD-matrix is heated to room
Andor CCD
button.
panel of the
Functions Andor CCD / Renishaw
button in the Main
input field in
Set T(°C)
49