Adjusting Signal Detection With The Renishaw Ccd Camera - NT-MDT NTEGRA Spectra Instruction Manual

Fig. 9-10. Spectrum collected over a limited band of the CCD-matrix
9.3.2. Adjusting Signal Detection with the Renishaw CCD
camera
1. Switch to the
Spectra
2. Go to the
Renishaw CCD
tab.
Spectra
3. Select the
Use Renishaw CCD for scanning
Adjustment panel (Fig. 9-11).
4. Select the
Use trigger mode
5. Adjust parameters of spectrum detection by the CCD camera through the following
steps:
a. Open the
Spectral acquisition setup
button.
Settings
Chapter 9. Measuring with the Confocal Microscopy Mode
tab (click
tab by clicking the corresponding title in the left top of the
Fig. 9-11. Instrument Parameters Adjustment panel
option.
button on the Main Operations Panel).
option in the Instrument Parameters
window (Fig. 9-12) with the
Measurement
37