Stopping Port Monitoring - 3Com LANPLEX 6000 User Manual

Stopping Port
Monitoring
Top-Level Menu
system
display
ethernet
add
fddi
remove
tokenring
start
bridge
stop
ip
snmp
analyzer
script
logout
CAUTION: If you receive the above message, check your analyzer port
configuration before proceeding. An incorrect configuration will result in
frames being continuously flooded throughout your bridged network.
You are then prompted for an FDDI port through which the data should be
forwarded as shown below:
Select FDDI port (1-2):
Once you successfully configure a port to monitor, all the data received and
transmitted on the port is forwarded to the selected analyzer port, as well
as processed normally.
After analyzing an Ethernet port, you may want to remove it from the
Roving Analysis configuration.
To remove a port configured for monitoring:
1 From the top level of the Administration Console, enter:
analyzer stop
2 Enter the slot number of the module on which the port is monitored.
3 Enter the number of the Ethernet port currently being monitored.
Port data is no longer copied and forwarded from that port to the selected
analyzer port.

Stopping Port Monitoring

2
11-7