3Com LANPLEX 6000 User Manual page 24

1-6 C 1: LAN
HAPTER
Table 1-3 Ethernet, FDDI, & Token Ring Configuration Options (continued)
Option
Set FDDI path
parameters
Set FDDI MAC
parameters
Assign FDDI MACs to
stations and paths
Set FDDI port
parameters
Label an FDDI port
Assign FDDI ports to
stations and paths
(continued)
6000 A
PLEX DMINISTRATION
Description & Quick Access
Set the minimum value for the TVX timer, the minimum
value for the T-Max timer, and the maximum value for the
T-Req timer.
Quick Commands:
fddi path tvxLowerBound
fddi path tmaxLowerBound
fddi path maxTreq
Set the parameters for the frame error threshold and the
not copied threshold, and enable/disable LLC service.
Quick Commands:
fddi mac frameErrorThreshold
fddi mac notCopiedThreshold
fddi mac llcService
fddi mac path
After setting the backplane paths mode, select a station for
each MAC in your system and assign the MACs to paths.
Station and path selections vary depending on the
backplane path mode.
Quick Command:
fddi mac station
fddi mac path
Set the parameters for link error rate alarm threshold and
link error rate cut-off threshold. Assign the A and B ports to
either the primary or secondary rings.
Quick Commands:
fddi port lerAlarm
fddi port lerCutoff
fddi port path
Give an FDDI port a unique name. Useful for port
identification when managing the system.
Quick Command:
fddi port label
After setting the backplane paths mode, select a station for
each FDDI port in your system and assign the ports to
paths. Station and path selections vary depending on the
backplane path mode.
Quick Commands:
fddi port station
fddi port path
O
VERVIEW
For More Information, Go to...
Chapter 9: Administering FDDI
Resources
page 9-8, page 9-9
Chapter 9: Administering FDDI
Resources
page 9-16, page 9-17, page 9-18
Chapter 9: Administering FDDI
Resources
page 9-25, page 9-26
Chapter 9: Administering FDDI
Resources
page 9-21, page 9-22, page 9-23
Chapter 9: Administering FDDI
Resources
page 9-22
Chapter 9: Administering FDDI
Resources
page 9-32, page 9-33