Displaying The Roving Analysis Configuration - 3Com LANPLEX 6000 User Manual

Configuration rules
Displaying the
Roving Analysis
Configuration
Port on switching
module chosen for
1
network analyzer
Network Analyzer
Figure 11-2 Monitoring Remotely Between Two LANplex Systems
You can have a maximum of 16 network analyzers connected to a system
and the following maximum number of ports monitored per module:
ESM — one port monitored
EFSM — eight ports monitored
The network analyzer cannot be located on the same segment as the port
you want to monitor. In general, you will configure one analyzer port and
from there monitor one Ethernet port at a time.
You may want to display the Roving Analysis configuration to see which
ports on a module are designated as analyzer ports and which ports are
currently being monitored on a specific module.
When you display the Roving Analysis configurations for a system, you
receive:
A list of analyzer ports on the module (ports connected to a network
analyzer), including the slot number, the Ethernet port number, and the
Ethernet MAC address of the port
A list of ports being monitored on the module, including the slot number,
the Ethernet port number, and the Ethernet MAC address of the port to
which the analyzer is attached
Displaying the Roving Analysis Configuration
FDDI
(Connection through the LMM A/B ports)
Remote port to monitor on
2 another LANplex system's
switching module
LANplex 6012
11-3