3Com LANPLEX 6000 User Manual page 250

2 I
NDEX
ASCII-based editor
and scripts 2-14
for packet filters 14-18
B
backplane paths mode
assigning MACs to stations 9-25
assigning ports to stations 9-32
changing to multi-station 9-2
configuring 9-3
defining 9-1, 9-2
backup
saving NV data 7-2
baseline
displaying current 6-2
enabling and disabling 6-2
setting 1-2, 6-2
why set one 6-1
baud rate
serial port 1-4
bell, warning 4-2
blocking state 13-5
bridge
address threshold, setting 1-7, 12-8
aging time, setting 1-7, 12-8
designated 13-3
IP fragmentation, enabling 12-6
IPX Snap Translation, enabling 12-6
menus 2-6
mode, defined 12-3
mode, setting 1-7, 12-4
Spanning Tree
bridge priority, setting 12-10
enabling 12-9
forward delay, setting 12-12
hello time, setting 12-11
maximum age, setting 12-10
Spanning Tree configurations 1-8
statistics, displaying 12-1
See also packet filter, ESM, and EFSM
bridge port
MAC addresses
adding 13-13
flushing 13-14
freezing 13-15
listing 13-12
removing 13-13
multicast limit, setting 13-7
Spanning Tree
configuring 1-8
enabling 13-8
path cost, setting 13-9
port priority, setting 13-10
states defined 13-5
static address configuration 1-8
statistics, displaying 13-1 to 13-3
broadcast address 3-6
bulletin board service B-1
C
code. See scripting and packet filter
command
and entering values 2-10
using 2-9
community strings
and multiple agent mode 3-20, 3-22
setting 1-5, 3-22
values 3-21
CompuServe B-2
connectPolicy
configuring 9-8
Control keys
enabling 1-3, 2-12
Control Panel
locking 1-3
write access 2-13
conventions
notice icons 3
cost
of IP interface 3-6
Spanning Tree settings 12-4, 13-3, 13-9
See also metric
CTL-C (abort) 1-3, 2-12
CTL-X (reboot) 1-3, 2-12
D
DAS configuration 9-34
datagrams, statistics 3-17
date
formats 4-5
setting 1-3, 4-4
default route
configuring 1-4
defined 3-10
removing 3-13
setting 3-13
destination address
for SNMP trap reporting 3-26
destination address group mask (DAGM) 15-1
destination IP address
in routing table 3-10