Flushing Trap Destinations - 3Com LANPLEX 6000 User Manual

Top-Level Menu
system
ethernet
display
fddi
mode
display
tokenring
community
addModify
bridge
trap
remove
ip
flush
snmp
smtProxyTraps
analyzer
script
logout

Flushing Trap Destinations

When flushing the SNMP trap reporting destinations, you remove all trap
destination agent and address information for the agent.
To flush all SNMP trap reporting destinations:
1 From the top level of the Administration Console, enter:
snmp trap flush
If the system is set for single agent SNMP mode, you are automatically
prompted to flush the trap destinations. Proceed to step 3. If the system is
set for multiple agent SNMP mode, you are prompted for the agent(s) by
slot.
2 Enter the slot number(s).
You receive the following prompt:
Are you sure? (n/y) [y]:
3 Enter (yes) or (no) at the prompt.
y n
If you enter , the addresses are immediately flushed. If you enter
y
returned to the previous menu.
Setting up SMT Event Proxying
FDDI SMT events, which occur on the FDDI ring, may be reported to
stations through the Status Report Protocol. Several SNMP traps, defined in
the LANplex Optional FDDI MIB, correspond to some of these events and
conditions. If you want remote SMT events to be reported by a LANplex as
SNMP traps, you must enable proxying of remote SMT events in that
LANplex system.
Setting Up SNMP on Your System 3-27
, you are
n