3Com LANPLEX 6000 User Manual page 226

15-10 C 15: C
HAPTER
Address group
example
Port group example
A
ONFIGURING DDRESS AND
Enter the ports in the syntax:
< Ethernet | E | FDDI | F > [port] < port number >
As you enter addresses and ports, the system attempts to remove them
from each of the modules on which the group is loaded.
If the address or port is not found in the group, a warning message is
displayed, as shown below:
Warning: Specified address was not a member of the address
group.
OR
Warning: Specified port was not a member of the port
group.
When this message occurs, the specified address or port is ignored and you
are prompted for the next one to be removed.
An example of removing addresses from an address group is shown below.
In this example, two Ethernet addresses are removed from the Marketing
address group.
Select address group to be modified [1-4]:
Removing addresses from group 4 - Marketing
Enter the addresses to be removed - type q to return to the menu:
08-37-21-65-78-c4
Address:
Address: 08-42-21-84-78-f1
q
Address:
An example of removing ports from a port group is shown below. In this
example, an Ethernet and an FDDI port are removed from the Education
port group.
Select port group to be modified [1-4]:
Removing ports from group 4 - Education
Enter the ports to be removed - type q to return to the menu:
Port: FDDI 1
Ethernet 4
Port:
q
Port:
P G U P
ORT ROUPS TO SE IN
F
ACKET ILTERS
4
4