3Com LANPLEX 6000 User Manual page 23

Table 1-2 Management Access Configuration Options (continued)
Option
Set the SNMP mode
Configure SNMP
community strings
Configure SNMP
trap reporting
Table 1-3 Ethernet, FDDI, & Token Ring Configuration Options
Option
Label an Ethernet port Give an Ethernet port a unique name. Useful for port
Set the Ethernet port
state
Set the FDDI
backplane ring mode
Set FDDI station
parameters
(continued)
Description & Quick Access
Specify whether the system is managed with a single
agent or with multiple agents — one for each logical
device (chassis, bridge, router) in the system.
Quick Command:
snmp mode
Specify the type of authorization for SNMP management
(read-only or read-write).
Quick Command:
snmp community
Specify which SNMP traps from which IP addresses are
reported to an SNMP-based external network
management application.
Quick Command:
snmp trap
Description & Quick Access
identification when managing the system.
Quick Command:
ethernet label
Enable or disable an Ethernet port to control whether the
port sends and receives frames.
Quick Command:
ethernet portState
Set the FDDI backplane rings for single station mode or
multi-station mode. Perform prior to other FDDI setup.
Quick Command:
fddi backplane
Set parameters for connection policies, the neighbor
notification timer, and status reporting.
Quick Commands:
fddi station connectPolicy
fddi station tNotify
fddi station statusReporting
Configuration Options
For More Information, Go to...
Chapter 3: Configuring
Management Access to the System
page 3-22
Chapter 3: Configuring
Management Access to the System
page 3-25
Chapter 3: Configuring
Management Access to the System
page 3-26
For More Information, Go to...
Chapter 8: Administering Ethernet
Ports
page 8-7
Chapter 8: Administering Ethernet
Ports
page 8-8
Chapter 9: Administering FDDI
Resources
page 9-3
Chapter 9: Administering FDDI
Resources
page 9-4, page 9-5
1-5