Displaying Groups - 3Com LANPLEX 6000 User Manual

Port group example
Displaying
Groups
Top-Level Menu
system
display
ethernet list
mode
list
fddi display
ipFragmentation
display
create
tokenring
ipxSnapTranslation
create
delete
bridge
addressThreshold
delete
edit
ip
agingTime
copy
load
snmp
stpState
addAddress
assign
analyzer
stpPriority
removeAddress
unassign
script
stpMaxAge
addressGroup
logout
stpHelloTime
portGroup
stpForwardDelay
port
packetFilter
group mask of 1 (the bit set in the mask) and the address group mask is
loaded into slots 3, 6, and 11.
Address Groups
Address Group 1 - Accounting
Address group mask - bit 1
Slot 3, 6, 11
Address Group 2 - Development
Address group mask - bit 6
Slot 4
Address Group 3 - Sales
Address group mask - bit 3
Slot 5, 7, 10
An example of listing port groups is shown below. In this example, two port
groups are defined in the system. The first port group has an id of 1 and the
name Sales. This group uses a port group mask of 7 and is loaded into slots
4, 5, and 9 (the bit set in the mask).
Port Groups
Port Group 1 - Sales
Port group mask - bit 7
Slot 4, 5, 9
Port Group 2 - Manufacturing
Port group mask - bit 23
Slot 4
The display of an address or port group shows the group id, the name of
the group, and all the addresses or ports included in that group.
To display address or port groups:
1 From the top level of the Administration Console, enter the following to
display an address group:
bridge packetFilter addressGroup display
Or enter the following to display a port group:
bridge packetFilter portGroup display
2 Enter the id number of the address or port group you want to display.
The address or port group you selected is displayed.

Displaying Groups

15-3