3Com LANPLEX 6000 User Manual page 224

15-8 C 15: C
HAPTER
Top-Level Menu
system
display
ethernet list
mode
list
display
fddi
ipFragmentation
display
tokenring create
ipxSnapTranslation
create
delete
bridge
addressThreshold
delete
edit
ip
agingTime
copy
load
snmp
stpState
addAddress
assign
analyzer
stpPriority
removeAddress
unassign
script
stpMaxAge
addressGroup
logout
stpHelloTime
portGroup
stpForwardDelay
port
packetFilter
A
ONFIGURING DDRESS AND
1 From the top level of the Administration Console, enter the following to add
addresses to an address group:
bridge packetFilter addressGroup addAddress
OR enter the following to add ports to a port group:
bridge packetFilter portGroup addPort
2 Enter the number of the group to modify.
3 Enter the addresses or ports to add to the group. Enter
the addresses or ports.
Enter the addresses in MAC format as:
xx-xx-xx-xx-xx-xx
Enter the ports in the syntax:
< Ethernet | E | FDDI | F > [port] < port number >
As you enter each address or port, an attempt is made to add it to each of
the modules on which the group is loaded.
If the address or port you enter is already a member of the group, a
message is displayed, as shown below, and the address or port is ignored.
Error: Address already in address group
OR
Error: Port already in port group
For address groups, if any of the modules fail to accept the additional
address, the address is not added to the group and an error message is
displayed as follows:
Error: No room in group for additional address.
The point at which a module runs out of room for additional addresses
depends on the following:
The type of module
The number of addresses currently in the address table
The number of unique addresses configured across all address groups on a
module. (Each statically configured address and each unique address
assigned to one or more address groups consumes one address storage
location.)
P G U P
ORT ROUPS TO SE IN
F
ACKET ILTERS
after entering all
q