Setting Passwords - 3Com LANPLEX 6000 User Manual

4-2 C 4: A
HAPTER DMINISTERING
Module entries
Warning messages
Setting
Passwords
Y S E
OUR YSTEM NVIRONMENT
The display contains the following general system information:
The system type (LANplex 6004)
System ID
Software version
Software build date and time
The display also has one entry for each module in the system listing:
Slot number
Module status (On-line or Off-line)
Type of module (LMM+, FCM, ESM, EFSM, TRSM)
Hardware revision number of each module
You will also see a warning message in the display and the system bell will
ring for any of the following conditions:
System temperature has exceeded the maximum level for normal operation
Fan failure has been detected
Power supply failure has been detected (if redundant power supply is
present)
NOTE: You can turn off the system bell by pressing any key on the LANplex
system's control panel.
The Administration Console supports three levels of password: one for
browsing (read), one for configuring network parameters (write), and one
for full system administration (administer).
The initial passwords stored in the nonvolatile memory of the LMM+ are
null. You can only change the password if you enter the Console using the
administer access level.