3Com LANPLEX 6000 User Manual page 54

3-8 C 3: C
HAPTER ONFIGURING
Top-Level Menu
system
ethernet interface
fddi
route display
tokenring
arp
define
bridge rip
modify
ping
ip remove
statistics
snmp
analyzer
script
logout
M A
ANAGEMENT CCESS
If you do not assign all ports to this interface, ensure that you include the
port to which your network management station is attached.
To define an IP interface:
1 From the top level of the Administration Console, enter:
ip interface define
2 Enter the slot of the switching module for which you want to define an
interface.
You are prompted for the interface's parameters. To use the value in
brackets, press [Return] at the prompt.
3 Enter the IP address of the interface.
4 Enter the subnet mask of the network to which the interface is to be
connected.
5 Enter the broadcast address to be used on the interface.
6 Enter the cost value of the interface.
7 Enter the port(s) that you want to include in the interface. Separate
non-consecutive ports with commas (,). Enter a consecutive series of ports
using a dash (-).
See the example below:
Select slot {3-4} [3-4]: 3
Enter IP address:
Enter subnet mask [255.255.0.0]:
Enter broadcast address [158.101.1.255]:
Enter cost [1]:
Enter ports (1=FDDI,
T T S
O HE YSTEM
158.101.1.1
255.255.255.0
=Ethernet) (
2-9
|all): 2-4,8
1-9