Chapter 23
| Multicast Filtering Commands
MLD Snooping
ipv6 mld snooping
version
ipv6 mld snooping
vlan immediate-leave
Command Usage
◆
When a new upstream interface (that is, uplink port) starts up, the switch sends
unsolicited reports for all currently learned multicast channels out through the
new upstream interface.
◆
This command only applies when proxy reporting is enabled (see
Example
Console(config)#ipv6 mld snooping unsolicited-report-interval 5
Console(config)#
This command configures the MLD snooping version. Use the no form to restore
the default.
Syntax
ipv6 mld snooping version {1 | 2}
1 - MLD version 1.
2 - MLD version 2.
Default Setting
Version 2
Command Mode
Global Configuration
Example
Console(config)#ipv6 mld snooping version 1
Console(config)#
This command immediately deletes a member port of an IPv6 multicast service
when a leave packet is received at that port and immediate-leave is enabled for the
parent VLAN. Use the no form to restore the default.
Syntax
[no] ipv6 mld snooping vlan vlan-id immediate-leave
vlan-id - A VLAN identification number. (Range: 1-4094)
Default Setting
Disabled
Command Mode
Global Configuration
– 586 –
page
581).