power inline
maximum allocation
This command sets the maximum power allocation mode based on PD (powered
device) class or user configuration. Use the no form to restore the default setting.
Syntax
power inline maximum allocation mode {class | user}
no power inline maximum allocation mode
class - Power allocation is based on device classification.
user - Power allocation is based on user configuration as defined in the
power mainpower maximum allocation
the
power inline maximum allocation
Default Setting
class
Command Mode
Global Configuration
Command Usage
The IEEE standard does not define the maximum power of each PD class. The
following table is an example from Microsem's PoE IC implementation.
Table 78: Maximum PoE Based on PD Classification
PD Class
Class 0 (AF)
Class 0 (AT)
Class 1
Class 2
Class 3
Class 4
Example
Console(config)#power inline maximum allocation mode user
Console(config)#
Chapter 13
Interface Configuration command.
Maximum Power (Watts)
16.1
33.6
4.2
7.3
16.1
33.6
– 395 –
| Power over Ethernet Commands
Global Configuration command or