Permit, Deny (Standard Ipv6 Acl) (333 - Edge-Core ECS2100-10T Reference Manual

◆
Example
Console(config)#access-list ipv6 standard david
Console(config-std-ipv6-acl)#
Related Commands

permit, deny (Standard IPv6 ACL) (333)

permit, deny (Extended IPv6 ACL) (334)
ipv6 access-group (337)
show ipv6 access-list (338)
permit, deny
This command adds a rule to a Standard IPv6 ACL. The rule sets a filter condition for
packets emanating from the specified source. Use the no form to remove a rule.
(Standard IPv6 ACL)
Syntax
Default Setting
None
Command Mode
Standard IPv6 ACL
Command Usage
New rules are appended to the end of the list.
An ACL can contain up to 64 rules.
{permit | deny} {any | host source-ipv6-address |
source-ipv6-address/prefix-length}
[time-range time-range-name]
no {permit | deny} {any | host source-ipv6-address |
source-ipv6-address/prefix-length}
any – Any source IP address.
host – Keyword followed by a specific IP address.
source-ipv6-address - An IPv6 source address or network class. The address
must be formatted according to RFC 2373 "IPv6 Addressing Architecture, "
using 8 colon-separated 16-bit hexadecimal values. One double colon may
be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields.
prefix-length - A decimal value indicating how many contiguous bits (from
the left) of the address comprise the prefix; i.e., the network portion of the
address. (Range: 0-128)
time-range-name - Name of the time range. (Range: 1-32 characters)
– 333 –
Chapter 10
| Access Control Lists
IPv6 ACLs