Edge-Core ECS2100-10T Reference Manual page 284

Chapter 9
| General Security Measures
DHCPv4 Snooping
◆
When DHCP snooping is enabled, the rate limit for the number of DHCP
messages that can be processed by the switch is 100 packets per second. Any
DHCP packets in excess of this limit are dropped.
◆
Filtering rules are implemented as follows:
If global DHCP snooping is disabled, all DHCP packets are forwarded.
■
If DHCP snooping is enabled globally, and also enabled on the VLAN where
■
the DHCP packet is received, all DHCP packets are forwarded for a trusted
port. If the received packet is a DHCP ACK message, a dynamic DHCP
snooping entry is also added to the binding table.
If DHCP snooping is enabled globally, and also enabled on the VLAN where
■
the DHCP packet is received, but the port is not trusted, it is processed as
follows:
If the DHCP packet is a reply packet from a DHCP server (including
■
OFFER, ACK or NAK messages), the packet is dropped.
If the DHCP packet is from a client, such as a DECLINE or RELEASE
■
message, the switch forwards the packet only if the corresponding
entry is found in the binding table.
If the DHCP packet is from client, such as a DISCOVER, REQUEST,
■
INFORM, DECLINE or RELEASE message, the packet is forwarded if MAC
address verification is disabled (as specified by the
verify mac-address
enabled, then the packet will only be forwarded if the client's hardware
address stored in the DHCP packet is the same as the source MAC
address in the Ethernet header.
If the DHCP packet is not a recognizable type, it is dropped.
■
If a DHCP packet from a client passes the filtering criteria above, it will only
■
be forwarded to trusted ports in the same VLAN.
If a DHCP packet is from server is received on a trusted port, it will be
■
forwarded to both trusted and untrusted ports in the same VLAN.
◆
If DHCP snooping is globally disabled, all dynamic bindings are removed from
the binding table.
◆
Additional considerations when the switch itself is a DHCP client – The port(s)
through which the switch submits a client request to the DHCP server must be
configured as trusted (using the
the switch will not add a dynamic entry for itself to the binding table when it
receives an ACK message from a DHCP server. Also, when the switch sends out
DHCP client packets for itself, no filtering takes place. However, when the
command). However, if MAC address verification is
ip dhcp snooping trust
– 284 –
ip dhcp snooping
command). Note that