Line; Table 18: Line Commands - Edge-Core ECS2100-10T Reference Manual

Chapter 4
| System Management Commands

Line

Line
You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).

Table 18: Line Commands

Command
line
accounting commands
accounting exec
authorization commands
authorization exec
*
databits
exec-timeout
login
*
parity
password
password-thresh
*
silent-time
*
speed
*
stopbits
timeout login response
disconnect
terminal
show line
* These commands only apply to the serial port.
Function
Identifies a specific line for configuration and starts the line
configuration mode
Applies an accounting method to commands entered at
specific CLI privilege levels
Applies an accounting method to local console, Telnet or
SSH connections
Applies an authorization method to commands entered at
specific CLI privilege levels
Applies an authorization method to local console, Telnet or
SSH connections
Sets the number of data bits per character that are
interpreted and generated by hardware
Sets the interval that the command interpreter waits until
user input is detected
Enables password checking at login
Defines the generation of a parity bit
Specifies a password on a line
Sets the password intrusion threshold, which limits the
number of failed logon attempts
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
thresh command
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Sets the interval that the system waits for a login attempt
Terminates a line connection
Configures terminal settings, including escape-character,
line length, terminal type, and width
Displays a terminal line's parameters
– 114 –
Mode
GC
LC
LC
LC
LC
LC
LC
LC
LC
LC
LC
LC
password-
LC
LC
LC
PE
PE
NE, PE