Edge-Core ECS2100-10T Reference Manual page 48

Chapter 1
| Initial Switch Configuration
Configuring the Switch for Remote Management
To generate an IPv6 global unicast address for the switch, complete the following
steps:
1.
From the global configuration mode prompt, type "interface vlan 1" to access
the interface-configuration mode. Press <Enter>.
2.
From the interface prompt, type "ipv6 address ipv6-address" or "ipv6 address
ipv6-address/prefix-length, " where "prefix-length" indicates the address bits
used to form the network portion of the address. (The network address starts
from the left of the prefix and should encompass some of the ipv6-address
bits.) The remaining bits are assigned to the host interface. Press <Enter>.
3.
Type "exit" to return to the global configuration mode prompt. Press <Enter>.
4.
To set the IP address of the IPv6 default gateway for the network to which the
switch belongs, type "ipv6 default-gateway gateway, " where "gateway" is the
IPv6 address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
Console#show ipv6 interface
VLAN 1 is Administrative Up - Link Up
Address is 00-E0-0C-00-00-FD
Index: 1001, MTU: 1500
Address Mode is DHCP
IPv6 is enabled.
Link-local address:
fe80::260:3eff:fe11:6700%1/64
Global unicast address(es):
2001:db8:2222:7272::/64, subnet is 2001:db8:2222:7272::/64
Joined group address(es):
ff02::1:ff00:0
ff02::1:ff11:6700
ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#show ipv6 default-gateway
IPv6 default gateway 2001:db8:2222:7272::254
Console#
– 48 –