Ip Igmp Snooping Vlan Static - Edge-Core ECS2100-10T Reference Manual

Chapter 23
| Multicast Filtering Commands
IGMP Snooping
ip igmp snooping vlan
static
Command Usage
This command applies when the switch is serving as the querier
proxy host when IGMP snooping proxy reporting is enabled
Example
Console(config)#ip igmp snooping vlan 1 query-resp-intvl 20
Console(config)#
This command adds a port to a multicast group. Use the no form to remove the
port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4094)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
port-channel channel-id (Range: 1-8)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
Static multicast entries are never aged out.
◆
When a multicast entry is assigned to an interface in a specific VLAN, the
corresponding traffic can only be forwarded to ports within that VLAN.
Example
The following shows how to statically configure a multicast group on a port.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#
– 562 –
(page 549), or as a
(page 548).