Omron KM50 Communications Manual page 92

*6: Always set the LOW threshold to a lower value than the HIGH threshold. You cannot set the
values so that the HIGH threshold is lower than or equal to the LOW threshold.
*7: Addresses 002A (Active Power Alarm Setting), 004D, and 0053 have the following relation.
Addresses 002A and 004D (Active Power Alarm Setting (Output Terminal 1)) are for the
same parameter for KM50-C.
Addresses 002A and 0053 (Active Power Alarm Setting (Output Terminal 2)) are for the same
parameter for KM50-E.
*8: The alarm function is disabled if the upper limit threshold is set to the maximum value or the
lower limit threshold is set to the minimum value.
*9: If 3-ST (KM-E only) is set for the event input, the Three-state Target is changed to NONE. To
set the Three-state Target to something other than NONE, set the Event Input Setting to the
Pulse Input Count or ON Time Measurement before selecting a target.
3. 3 Parameter Area
3-51